Filter
Top Products
Chapter 2 Requesting An RFID Report
34
Custom Max Power
The menu item determines the maximum power level that the
calibration procedure will use when attempting to find the ideal
power level. To make the calibration work faster, decrease this
value to exclude the higher power levels. The default is 20.
EPC Mgr Report
This menu item enables EPC and label information to be sent out
the network port. This information can be used by an RFID tag data
and labels manager program. The default is Disable.
Non-RFID Warning
When this menu item is set to Enable, the printer checks to make
sure that non-RFID jobs are not being printed on RFID labels (to
prevent RFID labels from being wasted).
If RFID labels are installed in the printer, and a job is printed with at
least one form that contains no RFID commands, a fault will be
declared and the data for the forms that contain no RFID
commands will be absorbed.
The default is Disable.
Requesting An RFID Report
This procedure prints a summarized RFID report. (This report also
includes validator data if the printer has a validator.)
1. Press the PAUSE key to take the printer offline.
2. If necessary, press ↓ and
↵ at the same time to unlock the
↵ key.
3. Press TEST PRINT. Printer Tests displays.
4. Press + until ODV/RFID Report displays.
5. Press
↵ to print the report.
6. Press ↓ and
↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
7. Press PAUSE again to put the printer online.