Filter
Top Products
Enable RFID Motion
59
The acceptable value range is 1 to 64 bits
for each partition.
Enable RFID Motion
Purpose This command enables or disables RFID paper motion.
Be default, labels automatically print at the end of the
format. This command allows you to inhibit the label
from moving.
Format ^RM
a
^RM Enable RFID Motion command.
a The default is Y. The acceptable values
are Y (Yes, move the label) or N (No, do
not move the label).
Specify RFID Retries for a Block
Purpose This command specifies the number of times that the
printer attempts to read from or write to a particular
block of a single RFID tag. The number will reflect in
the Auto Retry menu.
Format ^RR
a
^RR Specify RFID Retries command.
a
The default is 2. The acceptable value
range is 1 to 9.
RFID Setup
Purpose This command sets up parameters including tag type,
read/write position of the transponder, and error
handling.
Format ^RS
a
,
b
,
c
,
d
,
e
,
f
,
g
,
h
^RS RFID Setup command.
a
Selects the tag type. The acceptable
values range is 0 to 5. (This option is
currently not supported.)