Filter
Top Products
2–11Setting Up the Printer
Optional Media Rewind Hub
The printer can be equipped with a rewind hub that will automatically roll up the
label media for convenient handling. The hub is used in the following cases:
• When large quantities of labels must be printed as single batches for
later use
• When the automatic label peel-off dispenser option is used, to roll up the
used media backing after labels have been peeled off
To use the media rewind hub, perform the following steps.
1. Open the media supply door.
2. Ensure that the rewind bracket is installed (as shown in Figure 2–9).
3. Install a roll of the desired label media, following the above procedures,
and pull the media through the printer until approximately 18 inches is
free in front of the unit.
4. Loosen the thumbscrew, and remove the media retainer from the rewind
shaft as shown in Figure 2–10
.
Tear Bar
Rewind Bracket
Figure 2–9. Rewind Bracket Installation