Filter
Top Products
7 – SANblade Control iX
Configuring the QLA40xx HBA
IS0053301-00 D 7-15
Q
7.5.5
HBA Information Tabbed Page
The HBA Information tabbed page is for information only. It provides code versions,
etc. (see figure 7-14).
Figure 7-14. HBA Information Tabbed Page
The Statistics tabbed page is reserved for future use.
7.6
Configuring the QLA40xx HBA
The first step in using SANblade Control iX is to configure the QLA40xx HBA. After
starting SANblade Control iX (see section 7.2), double-click the name of your host
PC (left side of the screen), then highlight the QLA40xx HBA’s iSCSI name.
The selection tabs are displayed. Click the HBA Options tab, then follow these
steps:
1. Insert the desired IP address in the top section of the screen.
2. Insert the subnet mask:
a. From the Select Options list, click Network (see figure 7-15).
b. Enter the subnet mask.