Q-Logic 59042-07 A Switch User Manual


 
1 – Introduction
Related Materials
1-2 59042-07 A
0
1.2
Related Materials
The following manuals and materials are referenced in the text and/or provide
additional information.
SANbox2-8c/16 Switch Management User’s Guide, publication number
59022-10.
QLogic Switch Interoperability Guide v3.0. This PDF document can be
downloaded at http://www.qlogic.com/interopguide/info.asp#inter.
Fibre Channel-Arbitrated Loop (FC-AL-2) Rev. 6.8.
Fibre Channel-10-bit Interface Rev. 2.3.
Definitions of Managed Objects for the Fabric Element in Fibre Channel
Standard (draft-ietf-ipfc-fabric-element-mib-04.txt).
The Fibre Channel Standards are available from:
Global Engineering Documents, 15 Inverness Way East, Englewood, CO
80112-5776 Phone: (800) 854-7179 or (303) 397-7956
Fax: (303) 397-2740.
1.3
New in this Release
The following items are new in the current firmware release:
The switch supports a single firmware image and a pending image. Fallback
command is no longer supported.
Firmware Install command has been added to simplify the installation of
firmware.
Adding a fabric in SANsurfer Switch Manager always requires a user
account and a password. The UserAuthentication parameter has been
removed from the Set Setup System command.
Warning and failure temperature thresholds are fixed at 65° and 70° C
respectively and cannot be changed.
FC-SW-2 Compliant and FC-SW-2 Autosave parameters are changed to
Interop Mode and Interop Autosave respectively
I/O StreamGuard can be configured to automatically recognize an initiator
device with a QLogic HBA.