B – Command Line Interface
Set Command
59042-07 A B-35
0
Set Command
Sets a variety of switch parameters.
Authority Admin session for all keywords except Alarm, Beacon, and Pagebreak which are
available without an Admin session.
Syntax set
alarm [option]
beacon [state]
config [option]
log [option]
pagebreak [state]
port [option]
setup [option]
switch [state]
Keywords alarm [option]
Controls the display of alarms in the session output stream or clears the alarm log.
[option] can be one of the following:
clear
Clears the alarm log history. This value requires an Admin session.
on
Enables the display of alarms in the session output stream.
off
Disables the display of alarms in the session output stream.
beacon [state]
Enables or disables the flashing of the Logged-In LEDs according to [state]. This
keyword does not require an admin session. [state] can be one of the following:
on
Enables the flashing beacon.
off
Disables the flashing beacon.
config [option]
Sets switch, port, port threshold alarm, and zoning configuration parameters.
Refer to the “Set Config Command” on page B-37.
log [option]
Specifies the type of entries to be entered in the event log. Refer to the “Set Log
Command” on page B-48.
pagebreak [state]
Specifies how much information is displayed on the screen at a time according to
the value given by [state]. This keyword does not require an admin session. [state]
can be one of the following: