Filter
Top Products
4 – Installation
Installing a Switch
59042-07 A 4-19
0
The Heartbeat LED indicates the results of the POST. The POST tests
the condition of firmware, memories, data-paths, and switch logic
circuitry. If the Heartbeat LED blinks steadily about once per second,
the POST was successful, and you can continue with the installation
process. Any other blink pattern indicates that an error has occurred.
Refer to “Heartbeat LED Blink Patterns” on page 5-2 for more
information about error blink patterns.
The application opens with the Initial Start dialog. Refer to the SANbox2-8c/16
Switch Management User’s Guide for more information about using, exiting, and
uninstalling SANsurfer Switch Manager.
4.2.8
Configure the Switch
You can configure the switch using the SANsurfer Switch Manager application or
the command line interface. To configure the switch using SANsurfer Switch
Manager, click the Open Configuration Wizard radio button in the Initial Start
dialog, then click the Proceed button. The Configuration wizard explains and
prompts you for the following configuration information:
Temporary IP address
Temporary subnet mask
Archive template file
Switch domain ID (1–-239)
Domain ID Lock (Locked/Unlocked)
Switch name
Permanent IP address
Permanent subnet mask
Permanent gateway address
Permanent network discovery method
Date and time
Admin account password
Create a configuration archive?
Note: Refer to Table B-3 through Table B-8 for information on factory
configuration default values.