Filter
Top Products
B – Command Line Interface
Set Config Command
B-40 59042-07 A
0
switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets. Table B-10 describes the Set Config Switch
parameters.
IOStreamGuard I/O Stream Guard. Enables or disables the
suppression of RSCN messages. IOStreamGuard can
have the following values:
Enable – Suppresses the reception of RSCN
messages from other ports for which
IOStreamGuard is enabled.
Disable – Allows free transmission and reception
of RSCN messages.
Auto – Suppresses the reception of RSCN
messages under the following conditions: 1) The
port is connected to an initiator device with a
QLogic HBA, 2) The DeviceScanEnable
parameter is enabled. Auto is the default.
PDISCPingEnable Enables (True) or disables (False) the transmission of
ping messages from the switch to all devices on a
loop port. The default is True.
Table B-10. Set Config Switch Parameters
Parameter Description
AdminState Switch administrative state: online,
offline, or diagnostics. The default is
Online.
BroadcastEnabled Broadcast. Enables (True) or disables
(False) forwarding of broadcast frames.
The default is True.
InbandEnabled Inband management. Enables (True) or
disables (False) the ability to manage
the switch over an ISL. The default is
True.
Table B-9. Set Config Port Parameters (Continued)
Parameter Description