Filter
Top Products
B – Command Line Interface
Set Command
59021-08 B B-31
D
port [option]
Sets port state and speed for the specified port. The previous Set Config Port
settings are restored after a switch reset or a reactivation of a switch
configuration. Refer to the ”Set Port Command” on page B-46.
setup [option]
Changes SNMP and system configuration settings. Refer to the ”Set Setup
Command” on page B-48.
switch [state]
Changes the administrative state for all ports on the switch to the state given by
[state]. The previous Set Config Switch settings are restored after a switch reset
or a reactivation of a switch configuration. [state] can be one of the following:
online
Places all ports online
offline
Places all ports offline.
diagnostics
Prepares all ports for testing.
Examples The following examples enables and disables the beacon:
SANbox2 #> set beacon on
Command succeeded.
SANbox2 $> set beacon off
Command succeeded.