Filter
Top Products
Page ii 59021-08 B
D
SANbox2-16 Fibre Channel Switch
Installation Guide
© 2000–2004 QLogic Corporation
First Printed: May 2001
All Rights Reserved Worldwide.
Printed in U.S.A.
Information furnished in this manual is believed to be accurate and reliable. However, QLogic Corporation assumes no
responsibility for its use, nor for any infringements of patents or other rights of third parties which may result from its
use. QLogic Corporation reserves the right to change product specifications at any time without notice. Applications
described in this document for any of these products are for illustrative purposes only. QLogic Corporation makes no
representation nor warranty that such applications are suitable for the specified use without further testing or
modification. QLogic Corporation assumes no responsibility for any errors that may appear in this document.
QLogic, SANbox, SANbox2, SANbox Manager, SANblade, SANsurfer, SANsurfer Management Suite, and
Multistage are trademarks or registered trademarks of QLogic Corporation.
Gnome is a trademark of the GNOME Foundation Corporation.
Java and Solaris are registered trademarks of Sun Microsystems, Inc.
Pentium is a registered trademark of Intel Corporation.
Linux is a registered trademark of Linus Torvalds.
Microsoft, Windows NT, and Windows 2000/2003, and Internet Explorer are registered trademarks of Microsoft
Corporation.
Netscape Navigator and Mozilla are trademarks or registered trademarks of Netscape Communications
Corporation.
Red Hat is a registered trademark of Red Hat Software Inc.
SANmark is a registered trademark of the Fibre Channel Industry Association.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Document Revision History
Release, Revision A, November 2003
Update, Revision B, January 2004
Change Affected Section
User accounts are not stored in configdata file B.3.2
Alarm log is cleared when the switch is reset or
power cycled
”Hardreset Command” on page B-15
”Hotreset Command” on page B-18
”Reset Command” on page B-25
”Show Command” on page B-53
Set Alarm Clear requires an Admin session ”Set Command” on page B-30
Enable I/O Stream Guard only on initiators
FC-SW Auto Save recommendations
”Set Config Command” on page B-32