Filter
Top Products
4 – Installation
Installing a Switch
59021-08 B 4-17
D
4.2.7
Configure the Switch
You can configure the switch using the SANbox Manager application or the
command line interface. If you are using the command line interface, refer to
”Config Command” on page B-10 and ”Set Config Command” on page B-32. To
configure the switch using SANbox Manager, click the Open Configuration
Wizard radio button in the Initial Start dialog, then click the Proceed button. The
Configuration wizard explains and prompts you for the following configuration
information:
Refer to the SANbox2-8c/16 Switch Management User’s Guide for more
information about configuring a switch.
4.2.8
Cable Devices to the Switch
Connect cables to the SFP transceivers and their corresponding devices, and
then energize the devices. Device host bus adapters can have SFP (or SFF)
transceivers or GigaBit Interface Converters (GBIC). LC-type duplex fiber optic
cable connectors are designed for SFP transceivers, while SC-type connectors
are designed for GBICs. Duplex cable connectors are keyed to ensure proper
orientation. Choose the fiber optic cable with the connector combination that
matches the device host bus adapter.
Temporary IP address
Temporary subnet mask
Archive template file
Switch domain ID (1–-239)
Domain ID Lock (Locked/Unlocked)
Switch name
Permanent IP address
Permanent subnet mask
Permanent gateway address
Permanent network discovery method
Date and time
Admin account password
Create a configuration archive?