Filter
Top Products
Rev.1.10 Jul 01, 2005 page 243 of 318
REJ09B0124-0110
M16C/6N Group (M16C/6NK, M16C/6NM) 20. Flash Memory Version
Under development
This document is under development and its contents are subject to change.
20.3.1 EW0 Mode
The microcomputer enters CPU rewrite mode by setting the FMR01 bit in the FMR0 register to “1” (CPU
rewrite mode enabled) and is ready to accept commands. EW0 mode is selected by setting the FMR11 bit
in the FMR1 register to “0”. To set the FMR01 bit to “1”, set to “1” after first writing “0”.
The software commands control programming and erasing. The FMR0 register or the status register
indicates whether a program or erase operation is completed as expected or not.
20.3.2 EW1 Mode
EW1 mode is selected by setting FMR11 bit to “1” (by writing “0” and then “1” in succession) after setting
the FMR01 bit to “1” (by writing “0” and then “1” in succession). (Both bits must be set to “0” first before
setting to “1”.)
The FMR0 register indicates whether or not a program or erase operation has been completed as
expected. The status register cannot be read in EW1 mode.