Filter
Top Products
Printing the Sender’s Identification
This feature
prints
at the top of the message, the sender’s identification (the
CSI or RTI, see page 95) that appears on the display.
Tonal Signals
On this model the key on the ten keypad is used as the Tone key. Some
organizations offer you a special service by telephone, which you can access
by transmitting Touch tone or DTMF tones. If your phone service provides only
pulse dialing, or if you are calling over a digital network, the ability to generate
Tonal Signals will allow you to access these services. First, dial the other party
When you are through to the other end, press the Tone key and enter the code
number that is needed to access the required feature at the other terminal. You
do not need to press the Tone key if your machine is set up for dialing in Tone
Dial (DTMF) mode.
Using the Tone Key
1
Make sure that the machine is in standby mode, and that there is no
document in the feeder.
2
Pick up the telephone handset, or press the On Hook Dial key.
3
Dial the remote facility. Do not press the Start key.
4
After your line is connected to the remote facility, do the following:
❐ If your telephone line type is DTMF (Tone Dial): Go to step 5.
❐ If your telephone line type is Pulse Dial: Press the on the ten keypad. A dot
appears in the display.
5
Input the digits that you need to use the remote facility. After you have
finished your business with the remote facility, hang up.
Note: Do not press the Start key.
OTHER FEATURES Printing the Sender’s Identification
46