Filter
Top Products
12
QUICK START
Turning On the Power
Once the connections have been completed (p. 11), turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1. Before you turn the power on, check the following
points.
• Are peripheral devices connected correctly?
• Are the volume levels on the SP-303 and any amp or
mixer that is connected turned down to the lowest
settings?
2. Turn the SP-303’s power switch ON.
“303” appears on the display for a few seconds. The dots
will also blink.
fig.Q03
fig.Q04
3. Turn on the power of your amp/mixer etc.
4. Rotate the VOLUME knob to adjust the SP-303’s volume.
fig.Q05
5. Also adjust the volume of the connected amp/mixer etc.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
* If you turn on the power with a memory card already inserted,
the dots will blink until the memory card is detected. The unit
will not operate during this time.
Never turn off the power while the dots are blinking.
Turning Off the Power
1. Before you turn off the power, make sure that the
volumes of the SP-303 and the connected amp/mixer
are set to their minimum position.
2. Turn off the power of the amp/mixer etc.
3. Turn off the power switch of the SP-303.
Never turn off the power while the dots are blinking.
This may result in corruption of data in the SP-303’s
internal memory or on memory cards.
Dots