Filter
Top Products
39
Chapter 4. Changing the Sampling Settings
Chapter
4
2. Press the pad to which the sample you want to change
is assigned.
The pad will light, and the sample will sound. This pad
becomes the current pad.
* For gate playback, continue pressing the pad.
3. At the location where you wish to set the Start Point,
press [MARK].
[MARK] blinks, and “---” appears in the display.
If you now set the BPM (tempo), the End Point will
automatically be adjusted to the location of the beat
closest to the timing (i.e., an interval of beats measured
from the Start Point according to the BPM value) which
set when you press [MARK] at Step 4.
fig.r04-10
* To set the BPM, press [TIME/BPM], causing the button to
light, then either turn the CTRL 2 knob or press [TAP
TEMPO] four or more times.
4. At the location where you wish to set the End Point,
press [MARK] once again.
When [MARK] lights, the setting is complete.
* If the setting was not made as desired, press the lit [MARK]
button while the sound is still playing to make it go dark, and
re-do the procedure from step 1.
Adjusting only the End Point
fig.r04-11
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
2. Hold down [MARK] and press the pad to which the
sample you wish to change is assigned.
The pad will light, and the sample will sound. This pad
becomes the current pad.
* For gate playback, continue pressing the pad.
3. Release your finger from [MARK].
[MARK] blinks, and “---” appears in the display.
If you now set the BPM (tempo), the End Point will
automatically be adjusted to the location of the beat
closest to the timing (i.e., an interval of beats measured
from the Start Point according to the BPM value) which
set when you press [MARK] at Step 4.
* To set the BPM, press [TIME/BPM], causing the button to
light, then either turn the CTRL 2 knob or press [TAP
TEMPO] four or more times.
4. At the location where you wish to set the End Point,
press [MARK].
When [MARK] lights, the setting is complete.
* If the setting was not made as desired, press the lit [MARK]
button while the sound is still playing to make it go dark, and
re-do the procedure from step 1.
Adjusting only the Start Point
(End Point is the end of the sample)
fig.r04-12
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
2. Press the pad to which the sample you want to change
is assigned.
The pad will light, and the sample will sound. This pad
becomes the current pad.
* For gate playback, continue pressing the pad.
3. At the location where you wish to set the Start Point,
press [MARK].
[MARK] will blink.
Start point
newly adjusted End Point
timing at which
you pressed
[
MARK
]
beat beat beat beat
adjusted
1
3,4
2