Filter
Top Products
32
Chapter 3. Sampling
6. Press [REC].
[REC] will light, and the SP-303 will wait for an input
signal. “rdY” (ready) appears in the display.
When the input from the LINE IN or MIC rises above the
sampling start level, sampling will start.
When sampling begins, the display changes to “rEC.”
Never turn off the power while sampling is in progress.
Turning off the power at this point may result in
corruption not only of the sample currently being made,
but other samples as well.
7. When you wish to stop sampling, press the [REC]
button.
[REC] and the pad lights go out and sampling ends.
To stop auto sampling
If you wish to stop auto sampling, use the following procedure.
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
2. While holding down [CANCEL], press [REC].
[REC] will blink.
3. Turn the CTRL 3/MFX (LEVEL) knob all the way to the
left until “-0-” appears in the display.
4. Press [REC].
[REC] light goes out.
Making Samples with Effects
Added (Resampling)
With the SP-303, you can play back a sample that has effects
added to it, and then sample that sound, which is then
handled as a new sample. This process is called
“resampling.”
Here is an example describing the procedure for resampling
Pad 1 in BANK A with the Filter + Overdrive added, and
storing this to Pad 4 in Bank B.
fig.r03-05
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
2. Press [RESAMPLE], and confirm that the button has lit.
“LEV” appears in the display.
3. Select a pad to which a sample has already been
assigned to use as the resampling source.
Here, select Pad 1 in Bank A.
Press BANK [A], illuminating the button, then press Pad 1.
Pad 1 lights up, and the sample assigned to Pad 1 is
played.
4. Press [FILTER+DRIVE], and confirm that the button
has lit.
The Filter + Overdrive is turned on, and the effect is
applied to the sound from Pad 1 in Bank A.
Adjust the effect as needed by turning the CTRL 1 and
CTRL 2 knobs.
* You cannot change the sound of the effect with the CTRL 3/
MFX knob when [RESAMPLE] is lit. If you want to use the
CTRL 3/MFX knob to change the sound of the effect, press
[CANCEL]; the [RESAMPLE] light then goes off.
5
8
7
4
6,
10
,
12
3,
11
1
3,
11
7,
13
2
9