Filter
Top Products
INSTALLATION
6
Vista Remote 2 Installation and Operations Manual
Vista Remote 2 Installation
Installing the Vista Remote 2 is a very easy process and should be performed by a designated
administrator. The administrator will install, configure, and set-up user access profiles. A
network administrator will need to assign an IP address to the unit (if needed) and set-up
firewall and network access to the unit.
The following installation procedure is a guide to properly install and configure the Vista
Remote 2. The following items are needed to install the Vista Remote 2:
1. A valid IP address to assign to the unit (if not using DHCP feature)
2. VGA monitor
3. PS/2 keyboard
4. PS/2 mouse
5. RJ45 network cable
6. KVM Adapter cable (DB25M to PS/2F-PS/2F-HD15F)
7. CPU Adapter cable(s) (DB25M to PS/2M-PS/2M-HD15M)
Connecting the KVM station
Connect the KVM stations PS/2 keyboard, video monitor and PS/2 mouse cables to the
corresponding connectors on the KVM adapter cable as shown in Figure 2. The KVM station’s
video monitor should be equal or better than any of the connected computers. Connect the
DB25M end of the KVM cable to the KVM DB25F port on the rear panel of the Vista Remote 2
unit.
Figure 2. Connecting a KVM
KVM Adapter Cable
KVM Station