Filter
Top Products
54
Chapter 6 Basic setting and operation
2. Select either "Manual" or "DHCP" from IP configuration pull
down menu. When "DHCP" is selected, IP address, Subnet
mask, Default Gateway, DNS are automatically configured by
DHCP function. Only the DNS address allows you to set up
manually if the DNS address information is not provided on
your DHCP server. When selecting "Manual", configure all the
items manually. For further information, contact your network
administrator. The address must be entered as 4 number groups
separated by a dot like [192.168.001.101].
3. After completing the network configuration, press Set button to
register the network information. The Simple(Wireless) setting is
fixed, which cannot be changed from factory default value.
4. To apply the setting, press Set button. The network of the
projector starts re-booting and applies the setting. It takes about 20 seconds to complete. Close the
web browser and access to the login page again in 20 seconds.
On the screen of the projector, the “Please wait...” message will appear and switching operation will
start. Switching will take a while and after completing the operation, the “Ready for use” message will
appear. During the switching period, the projector cannot be operated.
When you use LAN4(Wireless) or LAN5(Wireless), the setting items of page [2] and [3] are activated
and you can setup Wireless LAN setting and Security setting. See the item " Configuring Wireless LAN
Setting and Security Setting" for further setting.
✐ When the IP address collides with the address of other equipment, the computer cannot communicate with the
projector. When the IP address collides with the address of other equipment, the computer cannot communicate
with the projector. Set an IP address again after selecting another LAN mode from "Change setting" or turning off
and then on the projector.