Filter
Top Products
Removal and replacement procedures 22
Processor
Removing a processor
1. Power down the server. See “Powering down the server” earlier in this chapter.
2. Extend the server from the rack. See “Extending the server from the rack” earlier in this chapter.
3. Remove the access panel. See “Removing the access panel” earlier in this chapter.
4. Remove the processor memory board. See “Processor memory boards” earlier in this chapter.
5. Remove the processor heatsink.
Figure 13 Removing the processor heatsink
6. Remove the processor.
Figure 14 Removing a processor
Installing a processor
CAUTION: If reusing the heatsink, clean and apply thermal grease to prevent thermal failure. The syringe in
this kit contains 1.0 gm (0.5 ml) or 0.5 gm (0.25 ml) of grease designed for use as a thermal interface
between the processor and the heatsink.
1. Open the ZIF socket lever. Be sure the lever is in the fully open position.
2. Align the processor with the socket.