Filter
Top Products
Removal and replacement procedures 36
Power button/LED assembly
To remove the power button/LED assembly:
1. Power down the server. See “Powering down the server” earlier in this chapter.
2. Extend the server from the rack. See “Extending the server from the rack” earlier in this chapter.
3. Remove the access panel. See “Removing the access panel” earlier in this chapter.
4. Unplug the cable from the diagnostic display board.
5. Push the locking tab until the opposite side comes out.
Figure 32 Removing the power button/LED assembly
Reverse the steps to replace the power button/LED assembly.