SPECIAL MODES
6-4
Margin shift
The margin shift function will automatically shift the text or image on the copy paper approximately 1/2" (10 mm) in
its initial setting.
1
Touch the [MARGIN SHIFT] key on the
SPECIAL MODES screen.
The margin shift setting
screen will appear.
The margin shift icon
( ) will also appear in
the upper left of the
screen to indicate that
the function is turned on.
2
Select the shift direction.
Touch a shift direction
key to select right or left.
The selected key will be
highlighted.
3
Set the shift amount as needed and touch
the [OK] key.
Use the and the
keys to set the shift
amount. The shift amount
can be set from 0" to 1" in
1/8" increments.
If a duplex module/2 x
500 sheet paper drawer
and duplex bypass/inverter unit are not installed,
the margin shift setting for back-side copies will
not be displayed.
4
Touch the [OK] key on the SPECIAL
MODES screen.
Return to the main screen of copy mode.
●The shift direction can be selected from right or left shift as
shown in the illustration.
One-sided copying
Original
Image shifted
to the right
Margin
Two-sided copying
Original
Or
Margin
Margin Margin
Image shifted
to the left
Image shifted
to the right
Image shifted
to the left
About the steps that follow
If a reversing single pass feeder is being used,
see pages 5-2 through 5-6. If the document
glass is being used, see pages 5-7 through 5-9.
To cancel the margin shift function, touch the
[CANCEL] key on the margin shift setting screen.
SIDE 1
(0 1)
inch
(0 1)
inch
SIDE 2
OKCANCEL
OK
1/2 1/2
ApollonII_general-copy_SEC.book 4 ページ ２００４年９月６日 月曜日 午後４時５７分
