Filter
Top Products
Optional Settings
169
6. Option
Settings
Setting 24: MULTI TTI
If you are using Department Control, you can press
1
to have the
department name (the name associated with the department code
entered by an operator to access the fax) appear at the top of each
transmitted document. This will appear in place of the name entered
in
Entering Your Name and Fax Number
in Chapter 1. Press
2
to turn
Multi TTI off (the sender’s name entered in Chapter 1 will appear).
♦
Initial setting: 2
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, or copying. Press
1
for 3 seconds,
2
for 1 second, or
3
for
no beep.
♦
Initial setting: 1
Setting 26: TELEPHONE BILLING CODE
This setting allows you to use Department Codes or direct billing
codes for telephone billing on a PBX. (Your dealer must first activate
Department Control or direct billing code entry.) Press
1
to turn
telephone billing on, or
2
to turn it off.
♦
Initial setting: 2
If you pressed
1
, the BILLING CODE DIAL selection will
subsequently appear. Press
1
if your PBX must receive the billing
code before dialing a telephone number, or
2
if it must receive the
billing code after dialling a telephone number. (Refer to your PBX
manual or consult your PBX administrator for this information.)
Note: If you select AFTER for the BILLING CODE DIAL selection, you
must press the REDIAL key after dialing if you use the SPEAKER key.
Setting 27: DEPARTMENT CODE DIGITS
Use this setting if you are using Telephone Billing and need to change
the number of digits of Department Codes to accord with your PBX’s
telephone billing system. Enter any number from
3
to
9
.
♦
Initial setting: 4
all-FO6700.book Page 169 Wednesday, August 30, 2000 1:17 PM