Filter
Top Products
Programming Auto-Dial Numbers
47
2. Sending
Documents
Clearing auto-dial numbers
Note: You cannot clear a number if it is used in a program or timer oper-
ation, if it is used to specify the relay fax machine in a relay group, or if it
is included in a Group Key. First clear the number from the operation or
group, then perform the following clearing procedure. To check where
the number is used, print out the Program/Group List, the Timer List,
and/or the Relay Group List as explained in Chapter 7.
1
Press these keys:
The display will show:
FUNCTION
3
1
01:FAX/TEL. # MODE
1=SET, 2=CLEAR
2
Press
2
to select CLEAR.
2
Chain Diaing for area and access codes
You can also program an area code or access code in a Rapid Key or
Speed Dial number using the above programming procedure. In Step
9, press
1
to set the number as a Chain Dialing number.
After you dial an area code or access code using a Rapid Key or Speed
Dial number set for Chain Dialing, the fax machine will wait for you
to dial the remainder of the number (you can dial the remainder of the
number by pressing a Rapid Key, by pressing the Speed Dial key and
entering a Speed Dial number, or by pressing numeric keys). Note that
the remainder of the number should
not be set
as a Chain Dial number
if programmed in a Rapid Key or Speed Dial number.
♦
The maximum number of digits that can be dialed at one time by
Chain Dialing is 60.
0
all-FO6700.book Page 47 Wednesday, August 30, 2000 1:17 PM