Filter
Top Products
DIS Digital Conference System User Manual
43
User Manual SW 6005 CAA ver 6.2 RevA.docx
4.7 Setup/Equipment
Conference Units 4.7.1
This screen is used to
configure the seat
assig
nment setting up
relations between
microphones, seat numbers
and computers running the
CUA Application.
Seats are automatically
created by the CU Interface
application when
information about new
units is received from the
CU 6105/6110 Central
Unit.
The
table can be sorted in
accordance to the various
columns by clicking the
header.
Figure 4.7-A
Note: If a seat has been created, it will not be deleted automatically if the unit is not connected to the CU
6105/6110 anymore.
Un-used ‘Seats’ have to be deleted manually.
Units in room
Type in the Room # to filter the list to shown only units placed in the room selected.
Room #
If rooms are linked together for combining system in more room, this field is used for
identifying which room, the unit is located in. The room number is selected by use of a
drop down box, with a list of configured rooms. The available rooms are set in
Setup/Rooms/Room Configuration.
Seat #
The seat number must be unique and is used to identify the seat on lists, reports and on
the mimic diagram. It can have a maximum of five numeric characters.
Serial #
Each microphone has a unique serial number encoded into the unit from the factory.
The number 000.000.000 must be used to create a seat with a computer but no
microphone.
Seat Type
This field is identifying the use of the seat, where the conference unit has been placed.
The entries are:
The other labels are only used for identifying the unit, but do not give any functionality.
DM unit
type
The connected unit is a Delegate Unit.
CM unit
type
The connected unit is a Chairman Unit.
DV unit
type
The connected unit is a Voting Unit.