Filter
Top Products
SVP 450 PLUS - SVD 500 PLUS
11
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH
3.10 Muting video button
Press MUTE for about 2 seconds. The picture will darken
while the projector stays on; the picture will reappear
immediately if you press the button again.
3.11 Normalised button
Press . The adjustments relative to contrast,
brightness, colour saturation, hue and peaking, stored in
the current bank, will be loaded automatically.
3.12 UPC button
Press UPC. It will turn on or off the converter that doubles
the input signal lines.
Note:
only on models with UPC.
3.13 Freeze button
Press . To have a still picture. When pressed again
the picture will run normally.
This function is only active if the UPC converter is
active.
3.14 Video menu
To select the input standard (PAL, SECAM, NTSC 3.58,
NTSC 4.53).
Press the button for at least 2 seconds to enter the
video menu.
The following menu will appear:
VIDEO MENU
NOISE RED.
STD SELECT.
BLANKING
WHITE BALANCE
UPC MENU
TLV SYNC
STD SELECTION
AUTO DETECT
PAL
SECAM
NSTC 3.58
NSTC 4.43
VIDEO MENU
NOISE RED.
STD SELECTION
BLANKING
WHITE BALANCE
UPC MENU
TLV SYNC
VIDEO MENU
NOISE RED. OFF
VIDEO MENU
NOISE RED.
STD SELEC.
BLANKING
WHITE BALANCE
UPC MENU
TLV SYNC
Press . Select SELEZ STD and press ENTER to
confirm, the following menu will be displayed:
The left arrow indicates the present setting. Use the arrows
to select the video input standard or the automatic
selection mode. Press ENTER to confirm.
Press EXIT to return to the previous menu. Press ESC to
exit the menu.
To turn on or off the noise reduction: this menu allows
you to activate a frequency filter.
Press for at least 2 seconds, the following menu will
be dispalyed:
Use the arrows to select NOISE RED. and press
ENTER to confirm, the following menu will be displayed:
Use the arrows to turn the noise reduction option on
and off.
Press EXIT to return to the previous menu. Press ESC to
exit the menu.
Note:
the noise reduction filter allows a reduction of the
noise on the video signal, which also implies a reduction
in the picture peaking.
To turn on or off the TLV sync: with this menu you can
synchronise signals with TRI-LEVEL synchronism for the
Japanese, high-definition system.
Press for at least 2 seconds, the following menu
appears: