Filter
Top Products
A P P E N D I X B
Remotelymanagingyour systemthroughan RS-232serialinterface
69 smarttech.com/kb/170401
3. Configure your serial interface settings using the values from the table in the previous section,
and then press ENTER.
An “invalid cmd= ? for help” message appears, and the > character appears as a command
prompt on the following line.
N O TE
If no message or an error message appears, your serial interface configuration isn’t correct.
Repeat step 3.
4. Type commands to configure your settings.
N O TE S
o
To see a list of commands available in the current operating mode, type ? and then press
ENTER.
o
If you’re using a terminal emulation program, turn on your program’s local echo setting to
see characters as you type them.
Projector programming commands
This section documents the projector programming commands and responses.
Projector power state controls
Device on/off and related controls.
Command\response definitions
Command Response Responds when powered off
on powerstate=[power state] yes
off [off option] powerstate=[power state] yes
get powerstate powerstate=[power state] yes