Filter
Top Products
A P P E N D I X B
Remotelymanagingyour systemthroughan RS-232serialinterface
71 smarttech.com/kb/170401
Command Response Responds when powered off
get usb1source usb1source=[current] yes
set usb2source [target] usb2source=[current] yes
get usb2source usb2source=[current] yes
Field definitions
Field Possible values Description
current input l VGA1
l
Composite
l
HDMI1
l
None
The input source to switch to. None is a non-
selectable input and is returned in response to a
get input command when the projector is turned
off.
target input l = VGA1
l = Composite
l = HDMI1
l = None
l = Next
Target input to set the input to. If the input is
next, the projector will move to the next item
from the possible values list and return a
response equivalent to if the user specified that
input directly.
current videoinputs l VGA1,
Composite,
HDMI1
Returns a comma separated list of the available
inputs on the projector. The strings returned in
this command must match the strings used for
the input selection from OSD. VGA1 and HDMI1
are local at projector. VGA2 and HDMI2 are at
UCP. The maximum could be 10 inputs in the
current list. (max 14 reserved).
current usb1source l VGA1
l HDMI1
l Disabled
Current value that the USB1 switch will be
enabled for.
target usb1source l = VGA1
l = HDMI1
l = Disabled
Value to set the usb1 switch enabled source to.
Note that this should not be the same as the
usb2source. If it is, USB1 will be used and
USB2 is ignored.
current usb2source l VGA1
l HDMI1
l Disabled
Current value that the USB2 switch will be
enabled for.