Filter
Top Products
SonicWALL UMA EM5000 Getting Started Guide Page 15
Connecting the SonicWALL UMA EM5000
to Your Network
To connect the SonicWALL UMA EM5000 to your network and
access the appliance management interface from a
management computer on your LAN, perform the following
steps:
1. If you are using the same management computer that you
used for initial configuration, unplug the crossover cable
from the management computer and from the
SonicWALL UMA EM5000.
2. Plug one end of the provided Ethernet cable (not the
crossover cable) into the eth0 port on the back of your
SonicWALL UMA EM5000.
3. Plug the other end of the Ethernet cable into an open port
on your local network hub or switch.
4. Adjust your management computer to its previous settings
prior to assigning it a static IP address on the default
appliance subnet.
5. Connect your management computer to your local network.
6. On the management computer, point a browser to the new
appliance IP address in the form:
http://<IP address>:<port>/appliance/
It is not necessary to provide the port in the URL if you kept
the default port.