Filter
Top Products
Page 32 Manually Configuring the System Role
To deploy your SonicWALL UMA EM5000 in the All In One role,
perform the following steps in the appliance management
interface:
1. Navigate to the Deployment > Role page. Under Host
Role Configuration, select the All In One radio button.
2. If this SonicWALL UMA EM5000 will connect to managed
appliances through a GMS gateway, type the gateway IP
address into the GMS Gateway IP field.
To determine if a GMS gateway is required, see the GMS
Gateway Recommendations section, on page 7.
3. If a GMS gateway will be used, type the password into both
the GMS Gateway Password and Confirm GMS
Gateway Password fields.
4. If this SonicWALL UMA EM5000 listens for syslog
messages on a non-standard port, type the port number
into the Syslog Server Port field. The default port is 514.
5. Configure the database settings as described in the
Configuring Database Settings section, on page 36.
6. Configure the Web port settings as described in the
Configuring Web Port Settings section, on page 38.
7. To apply your changes, click Update. To change the
settings on this page back to the defaults, click Reset.
Configuring the Database Only Role
The Database Only role is used in a multi-server SonicWALL
GMS deployment. In this role, the server is configured to run
only the database service. SonicWALL recommends that one of
the servers in a multi-server SonicWALL GMS deployment is
assigned a Database Only role.
Only the SonicWALL Universal Management Suite Database
service runs on a Database Only system.
The MySQL database engine is pre-installed on the SonicWALL
UMA EM5000. SonicWALL GMS can also use a MySQL
database or a Microsoft SQL Server database installed on a
server. Only the MySQL database included in the installer is
supported. On the Deployment > Role page in the
SonicWALL UMA EM5000 appliance management interface,
you can configure your SonicWALL GMS systems to use either
a MySQL or a SQL Server database.
To deploy your SonicWALL UMA EM5000 in the Database Only
role, perform the steps described in the Configuring Database
Settings section, on page 36.