Filter
Top Products
35
Chapter 2 Menus
Constituent Menus of the SET UP / INPUT CONFIGURATION Menu
This section describes the functions of the constituent
menus of the SET UP/INPUT CONFIGURATION
menu.
Notes
• The menu numbers (A, B1, C11 and so on) are not
displayed on the monitor screen.
For details of menu numbers, see page 20.
•An arrow (÷) following the description of an item
or setting in each menu indicates another menu which
appears or an operation which is executed when you
select that menu item or setting. If the description of
an item or setting is not followed by an arrow, it
indicates that selecting the item or setting finishes the
setting operation.
[C1](1/2)
INPUT CONFIGURATION menu (1/2)
Set input signal data for each channel.
xxCH: Current channel is indicated. Enter a channel
number with the numeric keypad if changing the
channel. The settings below will be stored as
information about the signal to be connected to
this channel.
FORMAT...: Select the input signal type. ÷ [C11]
SLOT NO: Enter the slot number.
INPUT NO: Enter the input connector number.
YC SEP...: Select a Y/C separation filter. ÷ [C12]
SYNC MODE: Select the sync signal.
INT: Use an internal sync signal.
EXT: Use an external sync signal.
SCREEN MODE...: Select the scan size. ÷ [C13]
SAFE AREA: Choose whether or not to display the
safe area (OFF or ON).
SCALE...: Select the safe area size. ÷ [C14]
APERTURE: Choose whether or not to use aperture
adjustment (OFF or ON).
VALUE: Enter the aperture adjustment value (0 to
200).
[C1](2/2)
INPUT CONFIGURATION menu (2/2)
Set input signal data for each channel.
xxCH: Current channel is indicated. Enter a channel
number with the numeric keypad if changing the
channel. The settings below will be stored as
information about the signal to be connected to
this channel.
FILTER: Switch the filter operation (OFF or ON)
when the monochrome display is selected.
CHANNEL NAME...: Give the channel a name. ÷
[C15]
CONTROL: Select whether to use local (“CH SET”)
or common (“PRESET”) values for contrast,
brightness, chroma, and phase.
PRESET: Use common data.
CH SET: Use values set for each channel.
COLOR TEMP...: Set the color temperature. ÷
[C16]
H PHASE: Set the horizontal picture position (–128
to +127).
1)
SAD H POSITION: Adjust the horizontal display
position of the safety area (–128 to +127).
1)
COPY...: Select a method for copying data from
elsewhere. ÷ [C17]
1) The monitor will not operate correctly if values above or
below the allowable range are entered.
[C11] FORMAT menu
Select the signal format.
COMPOSITE...: Composite signal. ÷ [C111]
YC...: Y/C signal. ÷ [C111]
COMPONENT...: Component or RGB signal. ÷
[C112]
SDI...: Serial digital signal. ÷ [C113]
Note
If there is no input connector or decoder corresponding
to a format, that format will not be selectable (the
cursor will skip over that item).