Filter
Top Products
49
Chapter 2 Menus
Constituent Menus of the SET UP / EXTEND Menu
[C7111] SLOT1 to SLOT9
The following message appears, requiring your
confirmation about data reloading.
DATA RESET TO
ITS FACTORY SETTING
AND MONITOR WILL RESTART
ARE YOU SURE?
OK : ENTER KEY
CANCEL : MENU KEY
OK: To continue, press the ENTER button. ÷
Resets the data and automatically turn the monitor
off and on again.
CANCEL: To cancel, press the MENU button. ÷
Returns to the RE-LOAD FACTORY DATA
menu. ([C711])
[C712] MEMORY CARD menu
Insert the monitor memory card into the MEMORY
CARD slot and select the operation to perform.
BACK UP SYSTEM DATA...: Write the data to the
monitor memory card. ÷ [C7121]
RE-STORE SYSTEM DATA...: Read the data from
the monitor memory card. ÷ [C7122]
Notes
•Before a monitor memory card can be used, it must
be formatted it with the FORMAT menu ([D4]).
• System data and memory card data ([D]) cannot be
stored on the same memory card. To store memory
card data, use another memory card.
• The BKM-12Y monitor memory card has a capacity
of 256 Kbytes. It can store either system data for up
to 8 monitors or 38 files of memory card data.
[C7121] BACK UP SYSTEM DATA menu
While the system is writing the data, a “–” mark blinks
at the top right of the menu. (It takes some time to save
the data.)
BACK UP SYSTEM DATA
IN PROGRESS...SYSTEM
This section describes the functions of the constituent
menus of the SET UP/EXTEND menu.
Notes
• The menu numbers (A, B1, C11 and so on) are not
displayed on the monitor screen.
For details menu numbers, see page 20.
•An arrow (÷) following the description of an item
or setting in each menu indicates another menu which
appears or an operation which is executed when you
select that menu item or setting. If the description of
an item or setting is not followed by an arrow, it
indicates that selecting the item or setting finishes the
setting operation.
[C7] EXTEND menu
Enter the password (ENTER PASSWORD [C71]).
When the correct password is entered, the following
item appears. Choose the function to execute.
RE-LOAD FACTORY DATA...: Restore factory
default data for the board installed in the selected
slot. ÷ [C711]
MEMORY CARD...: Read and write setting and
adjustment data by using the monitor memory
card. ÷ [C712]
RE-START MONITOR: Restart the monitor. ÷
[C713]
ADJ INT SIGNAL: Automatically adjust the
SETUP level and 100 IRE level of internal
signals. ÷ [C714]
[C711] RE-LOAD FACTORY DATA menu
Select a slot where a board is installed to reload factory
default data to the board. ÷ [C7111]
Note
You can only select slots 6 and 7. However, when the
optional board has been installed, you can also select
slot 2.