Filter
Top Products
38
Chapter 2 Menus
Assigning the Remote Control Functions
— REMOTE Menu
Overview
The remote control functions are set with the
REMOTE menu. With this monitor, both serial remote
control (REMOTE 1) and parallel remote control
(REMOTE 2) are possible. It is possible to
simultaneously use the REMOTE 1, and REMOTE 2
for control, but commands from REMOTE 2 have
priority. Therefore, it is impossible for the control
panel or REMOTE 1 to change items set by REMOTE
2.
There is no priority order between commands from
REMOTE 1 and the BKM-10R/11R control panel; it is
possible to set APERTURE to ON from REMOTE 1
and then set it to OFF with a control panel operation.
About monitor address and group numbers
The BKM-10R/11R or HDM-14E5U, BVM-14E5U/
14E5E/14F5U/14F5E/14G5U/14G5E/14G5A are able
to control up to 32 monitors connected via serial
remote connector (using the REMOTE 1 connector).
By giving each monitor a monitor address and group
number, it is possible to control just a specific monitor
or monitor group.
With the REMOTE menu, each monitor can be set
with a monitor address and group number, between 1
and 99.
The ADDRESS menu is used to select a particular
monitor or group by entering a monitor number or
group number.
For details of the ADDRESS menu, see “Selecting the
Monitor to Control —ADDRESS Menu” on page 55.
Note
The address number must differ from one monitor to
another. If two or more monitors have the same
address number, an operation error occurs.
Structure of the SET UP Menu [C] / INPUT REMOTE Menu [C2]
INPUT CONFIGURATION C1
REMOTE C2
PASSWORD C3
SYSTEM CONFIGURATION C4
ON SCREEN SET C5
ALIGNMENT C6
EXTEND MENU C7
REMOTE 1 CONFIG C21
REMOTE 2 CONFIG C22
REMOTE 2
MONITOR ADDRESS
GROUP ADDRESS
REMOTE MODE C211
1 PIN C221
2 PIN
3 PIN
4 PIN
5 PIN
6 PIN
7 PIN
8 PIN
CH (1/2)
BLUE ONLY (2/2)
Level 1 Level 2 Level 3 Level 4