Filter
Top Products
1-28
MVS-8000SF
AB C DE F GH J K L MN P R
1
2
3
4
5
6
7
8
9
10
11
12
13
D1
D2
D3
TP2
E1
TP1
TP3
D5
D6
E5
E3
E2
E4
E6
S1
CN1
TP201
TP202
TP203
TP204
E7
TP1000
TP2000
TP3000 TP3500 TP4000 TP4500 TP5000 TP5500
TP2500
TP1001TP2501 TP1501 TP7001 TP7501 TP6001TP6501
TP3001 TP3501 TP4501 TP5001
TP5501
TP4001
TP2001
TP1500 TP6000TP6500TP7000 TP7500
DI-41 board A side/Component side
..
..
. DI-40/41 board
<LED>
D1 (A-3) :
++
++
+12 V
+12 V power supply status indication.
Lit when the +12 V power is supplied.
If this LED does not light, the fuse may have blown.
D2 (A-4) :
++
++
+3.3 V
+3.3 V power supply status indication.
Lit when the +3.3 V power is supplied.
D3 (A-4) :
++
++
+2.5 V
+2.5 V power supply status indication.
Lit when the +2.5 V power is supplied.
D5 (A-5) : CONF1 status LED
H2 to L2 FPGA (Spartan II) CONFIG DONE status
indication.
Not lit when configuration is completed.
D6 (A-5) : CONF2 status LED
D10 to L10 FPGA (Spartan II) CONFIG DONE status
indication.
Not lit when configuration is completed.
<Switch>
S1 (A-6) : DI reset switch
Pressing this switch initializes the DI-40 and D-I41 boards.
<Connector>
CN1 (A-6) : ISP common connector
Used only for production in the assembly factory. Used for
program writing into the JTAG device with ISP.
<TEST terminal>
E1 (C-6), E2 (J-2), E3 (P-5), E4 (B-11), E5 (H-11), E6 (N-8),
E7 (A-7) : GND terminal bard
Use this terminal as the earth point for measuring the
respective check terminals.
1-8. Checks on Completion of Installation