Sun Microsystems 816-7727-10 Server User Manual


 
20 Sun Fire V440 Server Installation Guide July 2003
Install the Cable Management Arm
This procedure describes how to attach the cable management arm to a server that
is already installed in a cabinet.
You need the following components from the ship kit and the rackmounting kit to
install the cable management arm and to connect the cords and cables:
Cable management arm
Ethernet (RJ-45) cable
You also need two AC power cords, which are not supplied.
1. Loosen the four screws that secure the system to the left and right vertical rails at
the front of the cabinet.
2. Slide the server smoothly out of the cabinet about 3 inches (7.62 cm).
Sliding the server out of the cabinet enables easy access to the areas where you will
attach the cable management arm.
3. Attach one end of the cable management arm to the inner glide.
(Not supplied in kit)
AC power cords (2)
Ethernet RJ-45 cable
Cable management arm