Sun Microsystems 816-7727-10 Server User Manual


 
Chapter 2 Installing a Sun Fire V440 Server Into a 4-Post Cabinet 29
Connecting the Cords and Cables
The following figure shows the Sun Fire V440 server back panel and identifies the
AC power inlets and I/O ports.
Port Information
1 AC inlets Power cords connect to each AC inlet. Do not connect the
cordtoanACoutlet at this point. See “Connect the Power
Cords to the Server” on page 30.
2 Serial port (ttyb) This port provides standard serial functionality. Note that
the system controller serial management port is not a
standard serial port. See the Sun Fire V440 Server
Administration Guide for more information.
3 USB ports See the Sun Fire V440 Server Administration Guide for
information about devices you can connect to these ports.
4 Ethernet ports You use these ports to connect to your Ethernet network.
The left port is net0, and the right port is net1. See “Connect
Twisted-Pair Ethernet Cables” on page 32.
5 External SCSI port See the Sun Fire V440 Server Administration Guide for
information about the devices you can connect to this port.
6 Network management port
(NET MGT)
You use this port to access ALOM features by way of the
network.
7 Serial management port
(SERIAL MGT)
You use this, the default port, to attach the system console
device.
1
23 4 5
6 7