Filter
Top Products
Chapter 2 Sun Fire T1000 Server Diagnostics 43
▼ To Run the enablecomponent Command
The enablecomponent command enables a disabled component by removing it
from the ASR blacklist.
1. At the sc> prompt, enter the enablecomponent command.
2. After receiving confirmation that the enablecomponent command is complete,
reset the server for so that the ASR command takes effect.
Exercising the System with SunVTS
Sometimes a server exhibits a problem that cannot be isolated definitively to a
particular hardware or software component. In such cases, it may be useful to run a
diagnostic tool that stresses the system by continuously running a comprehensive
battery of tests. Sun provides the SunVTS software for this purpose.
This chapter describes the tasks necessary to use SunVTS software to exercise your
Sun Fire T1000 server.:
■ “Checking Whether SunVTS Software Is Installed” on page 43
■ “Exercising the System Using SunVTS Software” on page 44
Checking Whether SunVTS Software Is Installed
This procedure assumes that the Solaris OS is running on the Sun Fire T1000 server,
and that you have access to the Solaris OS command line.
sc> enablecomponent MB/CMP0/CH3/R1/D1
sc>SC Alert:MB/CMP0/CH3/R1/D1 reenabled
sc> reset