Filter
Top Products
62 Sun Fire T1000 Server Service Manual • January 2006
FIGURE 3-7 Removing the Power Supply
▼ To Replace the Power Supply
1. Unpackage the replacement power supply.
2. Slide the power supply into the chassis and engage the two alignment pins in the
rear of the chassis that mate with the power supply.
3. Tighten the fastener (
FIGURE 3-8) to lock the power supply into place in the chassis.
4. Redress the power cable through the midwall in the chassis and connect the cable
to the motherboard.
5. Perform the procedures described in “Common Procedures for Finishing Up” on
page 72.
6. Verify that the amber Fault LED on the replaced power supply and the Service
required
LED is not lit.
7. At the sc> prompt, issue the showenvironment command to verify the status of
the power supply.
Fastener
Power supply