Filter
Top Products
6-7
Chapter 6: MegaRAID Window and Menus
To open the MegaRAID Storage Manager Configuration Wizard, select a controller in
the left panel of the M
EGARAID STORAGE MANAGER window and then select OPERATIONS
J A
DVANCED OPERATIONS J CONFIGURATION J CONFIGURATION WIZARD.
This brings up the Configuration Wizard’s MODE SELECTION screen (Figure 6-4).
WARNING: It is recommended that you do not use both SAS and SATA drives in
the same array. Using different drive interfaces in this way could cause
unpredictable behavior, decreased performance, an increased error count, and
decreased MTBF.
NOTE: You cannot create or modify a storage configuration unless you are
logged on with administrator privileges.
Figure 6-4. Mode Selection Screen