Filter
Top Products
4-6
SPS 3000 Series Programmer’s Guide
Scanning For the First Time
Note:Depending on how your system is configured during installation of
the scan driver CAB file, the physical Compaq® iPAQ application
button that starts the Trigger application and the scanning
application launched may vary.
The information in this section assumes that the Trigger application
is mapped to Button 5, the Record Button (see iPAQ Pocket PC
Parts Used by the SPS 3000 on page 1-3), and that the ScanWedge
application is set to launch automatically.
To scan using the SPS 3000:
1. Insert the iPAQ into the SPS 3000 (see Inserting the iPAQ into the SPS 3000 on
page 2-1).
2. Press the scan trigger (Record Button) to launch the Trigger system tray
application.
3. When the Trigger application’s About box is dismissed (either manually or
automatically), ScanWedge launches.
4. Press the scan trigger a second time. This turns on the laser, which produces a red
scan beam. Verify that the red scan beam covers the entire 1-D bar code. If the bar
code is decoded, an audible beep occurs. ScanWedge places the bar code data in
any valid input field (any field that accepts cursor input).
Figure 4-5. Scanning a Bar Code
Scan Trigger (Default)
“Record Button”