Filter
Top Products
5-88 TimeVault™ User’s Manual 6000-100Ch5.fm Rev. D
Chapter 5: TimeVault-Generated Messages Error Messages
5.1.6 ERROR: Action (get or set) is not specified
Meaning: You have omitted the “get” or “set” parameter from the F100 NTP
Configuration command.
Recovery Action: Re-enter the command, specifying the desired action.
5.1.7 ERROR: Can’t open source file <NAME>
Meaning: The file containing the needed data is unavailable.
Recovery Action: Check file location and directory names to verify the path is accurate,
then re-enter the command.
5.1.8 ERROR: Can’t open dest file <NAME>
Meaning: The destination file is unavailable.
Recovery Action: Check file location and directory names to verify the path is accurate,
then re-enter the command.
5.1.9 ERROR: Can’t write file <NAME>
Meaning: Data from the source file cannot be copied to the destination file.
Recovery Action: Check file location and directory names to verify the path is accurate,
then re-enter the command.
5.1.10 ERROR: Configuration failed.
Meaning: Your attempt to configure new parameters was unsuccessful.
Recovery Action: Verify parameter values, then re-enter the command.
5.1.11 ERROR: Configuration type is not specified
Meaning: You did not specify the file type.
Recovery Action: Re-enter the command, specifying ACTS, NTP, and/or SNMP.