Symmetricom Time Server Network Card User Manual


 
6000-100Ch3.fm Rev. D TimeVault™ User’s Manual 3-41
Telnet Access Chapter 3: Remote Operation
4. Click Connect, the first item on the Telnet menu bar, then select Remote System.
The Connect dialog box appears:
5. In the Host Name field, enter TimeVault’s IP Address.
Do not change the text in the other two fields, which should read “Telnet” and
“VT100”.
6. Click Connect to start a Telnet connection to TimeVault.
If the connection was successful, a login prompt appears:
If an hourglass appears instead, it means the connection was not successful and
you should repeat steps 1-5.
7. Enter the login name guest.
A password prompt appears.
8. Enter the default password truetime (one word, all lower case).
A welcome message appears if the login and password are approved:
9. Begin your Telnet session by entering F-series commands.
3.2.2 Ending Telnet
There are three ways to end Telnet:
Close it from your terminal by selecting Exit from the Connect menu.
Enter an exit command, such as
exit, or quit.
Let it timeout. If no commands are received for 15 minutes, TimeVault
automatically terminates the session.