Filter
Top Products
4-64 TimeVault™ User’s Manual 6000-100Ch4.fm Rev. D
Chapter 4: Serial or Telnet I/O Functions Extended Function Commands
4.4.7 F100 IC – NET Port Network Configuration Entry/Request
To review the entire NET Port network configuration, send the following command:
F100<SP>IC<Enter>
An example of the response is:
F100 IP:206.54.0.21 SM:255.255.255.240
G:206.54.0.17N:E<CR><LF>
where N:E denotes Ethernet DIX.
4.4.8 F100 P – Change User Password
If you want to change a password, you must log in as the user for whom you want to
change the password (also see page 4-86). The maximum password size is ten characters.
To change the user password, send the following command:
F100<SP>P<Enter>
where:
F = ASCII character F
100 = unit function number
<SP> = space
P = specify Password command
<Enter> = input line terminator
The unit responds:
Enter new user password:
When you enter a new password, the unit responds with:
Enter it again:
Enter the same new password again, to confirm the spelling. If the same new
password has been entered twice, the unit responds with:
OK<CR><LF>
In this case, the new password will be used for the next login (serial or Telnet).
However, if the new password is entered differently the second time, the unit responds
with:
ERROR: Passwords do NOT match. New password rejected.
In this case, the old password will be used for the next login (serial or Telnet).
If you have forgotten your user name and/or password, you can go into bootloader
mode and reset them. In bootloader mode the unit recognizes the default user name
and password. You can then use F100 PR (see page 4-83) or F100 PRESETALL (see
page 4-82) to change the user name and password to defaults for use in the normal
mode, or you can use F100 PN (see page 4-82) and F100 P (the above command) to