6000-100Ch4.fm Rev. D TimeVault™ User’s Manual 4-83
Extended Function Commands Chapter 4: Serial or Telnet I/O Functions
When you enter a new user name, the unit responds with:
Confirm new user name:
Enter the same new user name again, to confirm the spelling.
If the same new user name has been entered twice, the TimeVault responds with:
User name change for xyz123 successfully changed
In this case, the new user name will be used for the next Telnet login. However, if the
new user name is entered differently the second time, the TimeVault responds with:
ERROR: User names do NOT match. New user name rejected.
In this case, the old user name will be used for the next Telnet login.
4.4.26 F100 PR - Password Reset
Use Password Reset when changing the current login user name and password to their
defaults.
To reset the passwords to factory defaults, send the following command:
F100 PR<Enter>
The unit responds:
Are you sure? (y/N)
If you answer “y” and press Enter, the unit executes the command.
As a safety feature, after sending this command, you have 10 seconds to respond
affirmatively (enter the letter “y”) to the confirmation prompt, after which the unit
executes the command and resets. Within that 10 second time period, any other response,
including no response, results in the unit canceling the command.
Unit example execution:
Default user name and password set : 2
4.4.27 F100 PL - Password Lock Request
Use Password Lock to view the password changing lockout setting for Telnet sessions.
To display the password lockout state, send the following command:
F100 PL<Enter>
An example unit response:
PASSWORD_SETTING_DISABLE_BIT = 0
If the lock is set to 1, changing the password is not possible (the password lock has been
set). If the lock is set to 0, changing the password is possible (the password lock has been
reset).