Filter
Top Products
4-84 TimeVault™ User’s Manual 6000-100Ch4.fm Rev. D
Chapter 4: Serial or Telnet I/O Functions Extended Function Commands
4.4.28 F100 PLS - Password Lock Set
Use Password Lock Set to lockout setting of passwords via Telnet.
To inhibit password changes, send the following command:
F100 PLS<Enter>
The unit responds:
Are you sure? (y/N)
If you answer “y” and press Enter, the unit executes the command.
As a safety feature, after sending this command, you have 10 seconds to respond
affirmatively (enter the letter “y”) to the confirmation prompt, after which the unit
executes the command and resets. Within that 10 second time period, any other response,
including no response, results in the unit canceling the command.
Unit example execution:
PASSWORD_SETTING_DISABLE_BIT = 1
4.4.29 F100 PLR - Password Lock Reset
Use Password Lock Reset to allow setting of passwords via Telnet.
To allow password changes, send the following command:
F100 PLR<Enter>
The unit responds:
Are you sure? (y/N)
If you answer “y” and press Enter, the unit executes the command.
As a safety feature, after sending this command, you have 10 seconds to respond
affirmatively (enter the letter “y”) to the confirmation prompt, after which the unit
executes the command and resets. Within that 10 second time period, any other response,
including no response, results in the unit canceling the command.
Unit example execution:
PASSWORD_SETTING_DISABLE_BIT = 0
4.4.30 F100 PE LIST - Peer List Request
Use Peer List to view the NTP peers being polled every 64 seconds.
To display the peers, send the following command:
F100 PE LIST<Enter>
An example unit response:
Peer no: 001 127.127.001.000
Peer no: 002 206.254.000.020