Filter
Top Products
TANDBERG Border Controller User Manual
xConfiguration Gatekeeper Alternates Alternate [1..5] Address: <IPAddr>
Set the IP address of an alternate Border Controller. Up to 5 alternates may be configured.
When the Border Controller receives a Location Request, all alternates will also be queried.
xConfiguration Gatekeeper Alternates Alternate [1..5] Port: <IPAddr>
Set the IP port of an alternate Border Controller. The default is 1719.
xConfiguration Gatekeeper AutoDiscovery: <On/Off>
Specifies whether or not the Border Controller responds to gatekeeper discovery requests from
endpoints. The default is On.
xConfiguration Gatekeeper CallsToUnknownIPAddresses: <Off/Direct/Indirect>
Specifies whether or not the Border Controller will attempt to call systems which are not registered
with it or one of its neighbor gatekeepers. If Off is selected, the Border Controller will not allow
calls to be made to unknown IP addresses. If Indirect is selected the Border Controller will not
place the call itself, instead it will LRQ its neighbor systems so that they may place the call. If
Direct is selected, the Border Controller will attempt to dial the IP address. See 3.5 for further
detail. The default is Indirect.
xConfiguration Gatekeeper CallTimeToLive: <60..65534>
Interval in seconds at which endpoints are polled to verify that they are still in a call. The default
is 120 seconds.
xConfiguration Gatekeeper DNSResolution Mode: <On/Off>
Determi nes whether or not DNS lookup of H.323 URI’s is enabled on this system. The default is
On.
xConfiguration Gatekeeper Downspeed PerCall Mode: <On/Off>
Determin es whether or not the system will attempt to down-speed a call if there is in sufficient
per-call bandwidth configured to fulfill the request. The default is On.
xConfiguration Gatekeeper Downspeed Total Mode: <On/Off>
Determin es whether or not the system will attempt to down-speed a call if there is in sufficient
total bandwidth available to fulfill the request. The default is On.
xConfiguration Gatekeeper ForwardLocationRequests: <On/Off>
Determines behavior on receipt of a location request (LRQ) from another Gatekeeper. If set to
on, the Border Controller will first try to resolve the request locally. If it cannot, the request will be
forwarded to neighbor Gatekeepers. The default is On.
xConfiguration Gatekeeper LocalDomain DomainName
DNS name of the domai n that the Gatekeeper is responsible for. Used when searching for
matching endpoint registrations.
xConfiguration Gatekeeper LocalPrefix: <prefix>
Set the local zone prefix of the system.
xConfiguration Gatekeeper Policy Mode: <On/Off>
48