Filter
Top Products
TANDBERG Border Controller User Manual
xConfiguration Zones TraversalZone [1..100] Match [1..5] Pattern Behaviour: <Strip/Leave>
Determin es whether the matched pattern should be removed from the alias before an LRQ is
sent to the indicated zone.
xConfiguration Zones Zone [1..100] Name: <name>
An administrator specified name for the zone.
xConfiguration Zones Zone [1..100] Gatekeeper [1..6] Address: <address>
Specifies the IP addresses of the gatekeepers in the zone. Multiple addresses allows support for
alternate gatekeepers.
xConfiguration Zones Zone [1..100] Gatekeeper [1..6] Port: <port>
Specifies the port on which the indexed gatekeeper is listening for RAS messages.
xConfiguration Zones Zone [1..100] HopCount: <count>
Specifies the hop count to be used when originating an LRQ.
xConfiguration Zones Zone [1..100] Monitor: <On/Off>
If zone monitoring is enabled, an LRQ will be periodically sent to the zone gatekeeper. If it fails
to respond, that gatekeeper will be marked as inactive.
xConfiguration Zones Zone [1..100] Match [1..5] Mode: <AlwaysMatch/PatternMatch/Disabled>
The zone match mode determin es when an LRQ will be sent to gatekeepers in the zone. If the
mode is set to AlwaysMatch the zone will always be queried. If the mode is set to PatternMatch,
the zone will only be queried if the alias queried for matches the corresponding pattern. If the
mode is set to Disabled the zone will never be queried.
xConfiguration Zones Zone [1..100] Match [1..5] Pattern String: <pattern>
The pattern to be used when deciding whether or not to query a zone. This is only used if the
zone’s match mode is set to AlwaysMatch.
xConfiguration Zones Zone [1..100] Match [1..5] Pattern Type: <Prefix/Suffix>
Deter mine s whether the pattern string being checked should ap pear at the beginning or end of
an alias.
xConfiguration Zones Zone [1..100] Match [1..5] Pattern Behaviour: <Strip/Leave>
Determin es whether the matched pattern should be removed from the alias before an LRQ is
sent to the indicated zone.
11.3 Command
The command root command, xcommand, is used to execute commands on the Border Controller.
To list all xcommands type
56