Filter
Top Products
TANDBERG Border Controller User Manual
11.3.7 DefaultLinksAdd
xCommand DefaultLinksAdd
Restores the factory default links for bandwidth control.
11.3.8 DefaultValuesSet
xCommand DefaultValuesSet Level <level>
Resets system parameters to default values. Level 1 will reset most parameters. There are
currently no level 2 parameters, so setting that level has the same effect as setting level 1. Level
3 resets all level 1 and 2 parameters as well as the following:
• IP address, subnet mask, gateway and interface speed. The default IP address is
192.168.0.100.
• COM port baud rate, speed, data bits, parity, stop bits
• SNMP community name and host address
• system name
• password
• option key
• release key
Note that DefaltValuesSet will not add the links with which the system ships from the factory. Use
the DefaultLinksAdd command to do that. Certificates and policy files are not removed
11.3.9 DenyListAdd
xCommand DenyListAdd <denied alias>
Add an entry to the deny list. This is used by the registration restriction policy.
11.3.10 DenyListDelete
xCommand DenyListDelete <index>
Removes the pattern from the deny list at the specified index.
11.3.11 DisconnectCall
xCommand DisconnectCall <callid>
Disconnects the specified call.
58