Filter
Top Products
Getting Started
AD007 User Manua l
7
Quick Setup
If the following conditions apply, you can go directly to the
appropriate setup procedure to install the adapter:
1. You have followed the instructions in the Read This First guide
and communicated the Ethernet hardware address of your adapter
to your network administrator.
2. Your network administrator has returned the card to you with an
IP address. (This means that the network administrator has
prepared the network by assigning a static IP address t hat is
mapped to the Ethernet Hardware addre ss of the ad apter.)
Note the information from the Network Information Card and
proceed as follows:
H If there is a DHCP/BOOTP server that is configured to allocate a
static IP address, go to page 25.
H If the DHCP/BOOTP server only allocate s a dynamic IP address
(whether or not the administrator has assigned a fixed IP
address), go to page 21.
H If there is no DHCP/BOOTP server and the network administra-
tor has assigned a static IP address to the adapter, go to page 18.
H If you want to set up the a dapter on a stand alone PC, go to
page 15.
H If the adapte r was p reviously configured on another network and
you wish to reset it to factory defaults and turn DHCP on, go to
page 14.
H If you wish to know more about DHCP/BOOTP servers and
installing the adapter on a network, continue reading on to the
next section.