Filter
Top Products
Getting Started
AD007 User Manua l
15
Setup Procedure 2 - Stand-Alone Operation
If the following conditions are true, you can manually set up the
adapter to work with a stand-alone PC.
H You want to set up t he a dapter apart from a network.
H The stand-alone PC does not have the appropriate settings and
connections to access the web pages on the adapter.
NOTE. Stand-alone operation requires a PC 10/100BaseT Ethernet
card and an Ethernet hub, crossover cable, or crossover adapter.
(The crossover cable or adapter is specifically designed for
connecting two nodes without a hub.)
To set the IP address in the adapter, do these steps:
1. Disconnect any ca ble that is currently connected to the adapter.
2. Power on the adapter and wait for the self test to complete. After
the self test is complete, the following stat es apply:
GPIB LAN LAN-Link POWER
-- -- -- -- -- -- -- -- -- -- ( 3 0 s e c o nd s el f - t e st , li g h t s b li n k a m b er ) -- -- -- -- -- -- -- -- -- -- --
-- -- -- -- -- -- -- (Self test pass, indicators momentarily blink green) -- -- -- -- -- -- --
Off Off Red Green
3. Locate the reset button on the bottom of the adapter. (For the
location of the reset button, see Figure 11 on page 48.)
4. Using a small tool or end of a paper clip, momentari ly push in the
reset button. This action loads the last known IP address. (For a
new adapter, the last known address is the factory defaul t IP
address of 192.168.1.1.)