Filter
Top Products
Section 3: Operation
3-6 Christie DS+60/DW30/Matrix 3000 User’s Manual 013-100149-02 Rev. 1 (01/07)
Table 3.1. Auto Setup
What an “Auto Setup” Does
OPTIMIZES: SETS TO DEFAULT:
Pixel Tracking Contrast
Pixel Phase Brightness
Size and Blanking Auto Input Level (off)
Vertical Stretch Detail (if video source)
Position Filter
Input Levels Luma Delay
NOTE: You must have an unlocked channel present to use Auto Setup.
Channel
Press
Channel
to select a specific source setup (channel) defined and stored in projector
memory. Once you enter a two-digit channel number (or, if there is a list displayed,
highlight it and press
), the display will automatically change and update
according to the numerous setup parameters defined for that channel. Note that a new
channel is automatically created if you adjust an image from a new source.
NOTE: Channel (
Channel
)
key behavior during a presentation depends on whether or not
the Display Channel List option is enabled in the Menu Preferences menu. You can
choose to use a scrollable list of channels when you press
Channel
, or you may prefer to
enter the desired channel number “blind”, i.e., without on-screen feedback. See Menu
Preferences later in this section.
Input 1
Press
Input 1
to display from the data or video input source connected to BNCs labeled
INPUT 1.
Input 2
Press
Input 2
to display from the DVI source connected to INPUT 2.
Input 3
Press
Input 3
to display from the composite video source connected to INPUT 3.
Input 4
Press
Input 4
to display from the S-video source connected to INPUT 4.
Input 5
Press
Input 5
to display from the INPUT 5 interface module installed in the Option 1 slot.
NOTE: If you have the new optional Dual SD/HD-SDI Module installed at
INPUT 5
you can connect two inputs – A and B. Whether you are displaying from
INPUT 5 or
from another input, press
Input 5
to display the input last used. Press
Input 5
again to toggle
to the other input.
Input 6
No function.
Channel
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6